Seeing Eminem's "Not afraid".

Not about being afraid.

It's about you doing the right thing.

These attacks, it is not only unnecessary,

but it is about cruelty.

How these people can get away with initiating attempt at this,

I have no idea. They must be charged.

 

 

I am driven to madness everyday because of these attacks.

These are people without conscience.

 

 

 

Earlier I have still seen "quarry" on the space escalator which was one of my first draft.

Later I improved it with compressed earth enwrapped inside an aluminum layer as cubes.

This not only protects it from the temperature and the elements/weather, but it will

have binding features in welding.

I have also improved the stacking method by creating the largest base, as the first layer

from the very bottom, calculating the height that must be reached, from layer to layer.

If Elon Musk, keeps misleading the public with my draft.

I have no idea where this person is coming from. The level of hostility, malice is off the charts.

There no honor at all.

Tracks will be following that base. Moving up. Some shapes must be pre-built with the tracks,

during build.

If I don't draw this, this person appears to be exploiting it. Because it is easily forgotten.

So I will be getting around to it, all of it.

But to deliberately follow up on my work based on my principles and claiming it as yours and burying the past itself would also be insanely wrong.

But there is no honor here is there.

 

Is that what is going on? It seems like Elon Musk is misleading again.

 

"pillars" within the cylinder may not be necessary. Just one cylinder going through another, and weldeld from within to be binded, and the layers to the sides then attacked following. A pillar
inside it is necessary if to be thinking about using hooks to lift up the cubes and dropping it for
interlocking later on.

Interlocking shapes can be easily designed. What must be thought of is how it will be placed.

It will most likely need to be dropped from top to bottom. Then finish off with welding.

Machines that will carry and extend its pole arms, rotated from a focal point of circular motion, or a type of small moving crane that can detach the cubes after movement is settled and place it with others can be made as well, following the bots required for follwing tracks and welding.

All this can be pre-programmed to the machines as would CNC. Probably scanning the edges of
the cubes to see if there is any interlocking slots that are not filled out is the way to go, within
confined parameters/region. So that it can be mostly, or if everything, can be automated.

Issue then is the second layer of cubes that will be placed on top of the base layer, and so forth.
So the cylindrical designes with the pillars (if pillars are needed to lift the cubes) and the metal layers will need to have pre-designed features to weld to each other after stacking. So hollow points or/concaved/or further interlocking in order to accomodate the incoming cubes. And so forth. It is slightly different from my original draft but the principles are the same.